Yachticon diesel remover for drinking water tanks 10 l

Product information 'Diesel remover for drinking water tanks 10 liters' Removes diesel and oil residues reliably and thoroughly from drinking water tanks and pipes. 10 liters are sufficient for 100 liters of contaminated water. Instructions for use: Drain the water tank containing the diesel fuel completely Pour the diesel remover into the empty water tank Fill the water tank with water Turn on all taps To allow the solution to work everywhere, leave the solution to work for at least 8 hours. It is best to drive the boat or caravan, or shake the tank accordingly, so that the diesel fuel emulsifies better in the water and all tank walls are wetted with the solution and everything can dissolve. Then rinse thoroughly and several times and disinfect the water tank with PURA TANK. Tip: for open-pored plastic tanks, the process must be repeated several times. If the diesel has already been absorbed deep into the plastic walls, the Products may only work to a limited extent. Contains: 5 % and above, but less than 15 % non-ionic surfactants, less than 5 % cationic surfactants Data sheet for information to the public according to Annex VII section D: Diesel remover for Drinking water tanks / Yachticon A. Nagel GmbH AQUA, C12-14 PARETH-12, TETRAPOTASSIUM PYROPHOSPHATE, PEG-2 LAURAMINE, TETRASODIUM GLUTAMATE DIACETATE. Safety information DANGER Hazard statements: H318 Causes serious eye damage. P102 Keep out of the reach of children. P262 Do not get in eyes, on skin or on clothing. P280 Wear protective gloves/protective clothing/eye protection/face protection. P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove existing contact lenses if possible. Continue rinsing. P310 Immediately call a POISON CENTER/doctor.