Philippi BTM 2 Batteries and tank monitor

Battery, tank and charging monitor BTM 2. Intuitive, 3.5" color TFT touchscreen graphic display with brightness sensor for automatic adjustment of the display brightness. Incl. NMEA 2000 interface. The BTM 2 is the further development of the proven battery tank monitor BTM Er Includes an integrated NMEA2000 interface, which makes the Batteries and Tank data available to the NMEA2000 network.This means that the battery and tank data can also be displayed on compatible plotters. New is also the operation at 12 - 48 V DC operating voltage, so that 48 V battery systems can also be monitored in conjunction with the Shunts SHE 348. All components have been further improved in terms of standby consumption so that the BTM2 can remain permanently connected to the battery without any problems. NMEA 2000 The N2K cable is also required for connection to the NMEA2000 network. The pluggable cable establishes the connection via aT-piece (5 0411 1149) to an NMEA 2000 on-board network or a Raymarine network (adapter cable Seatalk/NMEA 2000 A06045). Battery Monitoring Precise battery information about the current voltage, charge or discharge current, remaining time, Temperature and state of charge of the consumer battery. Historical values on the number of charge cycles, deep discharges and average depth of discharge give you an overview of how the Batteries are being used. Monitoring of the voltages of up to 2 starter or Bug Batteries is possible. Solar yield measurement If you also have a solar panel on board, you can use an additional power measurement shunt to display the power yield from your solar panel. Tank measurement All known philippi tank sensors such as TGT/ TGW, UTV, TDS/TDN and DFS can be connected, and existing tank sensors from other manufacturers with the signals 10-180O / 240-33O / 0-5 V / 0-10 V / 4-20 mA are also possible. Each tank can be individually configured for unique assignment, and adaptation to non-linear tank geometries is also possible. Individual tank alarms can be defined for monitoring purposes. Monitoring for ACE chargers An ACE-LIN interface integrated into the ACE automatic charger enables monitoring of the charging process, Display of the mains voltage, the charging phase, the battery temperature and the charging current. Setting the charging power for weak Land connection and the Silent mode (fan off) for models with high charging power > 60A. Alarm/Relay contact Also new is the potential-free changeover contact with which in conjunction with a remote-controllable FBR 265 battery main switch, voltage and, importantly, capacity-dependent energy management and deep discharge protection can be implemented. This allows the consumers to be switched off at an early stage before the threat of deep discharge and not only when the battery is deeply discharged. This is particularly important for lithium battery systems, whose flat discharge characteristic makes it impossible to switch off the voltage in good time. The Tank sensors, the "SHE300" Shunts, the "ACE-LIN" Chargers Interface and the "N2K cable" NMEA 2000 connection cable or the FBR265 Relay must be ordered separately. Operating voltage: 8-64 V Current consumption: max. 70 mA @ 12V, standby: 6 mA Dimensions: L 105 x W 105 x H 35 mm Mounting cut-out: 88 x 88 mm